





Some jobs need more than a standard setup. When a building is tall and the clearance requirements are serious, a high-lift configuration is the right call - and that's exactly what this job called for. We installed a 32x16 and a 13x13 overhead door, both set up with high-lift hardware to make the most of the vertical space inside the building.
High-lift systems are different from a typical overhead door installation. Instead of the tracks curving directly overhead at a low angle, they run vertically much higher up the wall before transitioning to the horizontal run near the ceiling. That means the door gets out of the way faster and clears more usable headroom. For a working farm shop with tall equipment moving in and out, that matters every single day.
The before shots tell the whole story. The old doors were worn, dingy, and clearly past their useful life. Getting those panels out and the new white sectional doors in - fitted clean and tight in the opening - made a noticeable difference in both function and appearance. A scissor lift was needed to get the high-lift hardware properly set at height, which is exactly why this kind of install isn't a DIY situation.
Whether it's a grain operation, an equipment shop, or any commercial building that sees heavy daily use, the door setup needs to be matched to how the space actually works. That's what we focus on - not just getting a door to open and close, but making sure the whole overhead door installation is built for the specific demands of the building and the people using it.
Big doors done right take the right equipment, the right hardware, and experience with high-lift configurations. We handle commercial and agricultural overhead door installations across the region, and jobs like this one are exactly what we're built for.